How to Make a Pincushion with a Frame and Crushed Walnut Shells

Did you know ground walnut shells make great pincushion filler? I was searching around for an alternative to polyester batting and found out everyone knew this but me. I thought about trying sawdust, since my husband is an occasional woodworker and it would be easy to get, but I liked how clean this option sounded. I finally got around to trying it in a couple of projects, and I don't think I'll be using anything else!

When I was gathering up items for my recent anniversary giveaway, I snagged a couple of these Create-a-Pincushion kits, keeping one for myself. The instructions call for batting, but I've worked out a way to make it using the walnut shells, and I'd love to share it with you.

This post contains affiliate links.

When you open up the kit, these are the pieces, plus instructions.

As you can see if you look closely at the finished product, it wasn't going to be possible to pile the shells up like you would if you use batting as instructed. Instead, I made a small container for those.

Cut a piece of muslin 7" by 3".  Fold so the two 3" edges meet, right sides together. 

Hand stitch medium length stitches with doubled thread about 3/8" from one edge.  Leave the needle and remaining thread attached. Pull tightly to gather, tie a knot and clip thread. Turn right side out.

Hand stitch the same way near remaining edge. Leave needle attached, but don't gather yet. Set the bag inside the pincushion base.  Fill with about 1/4 cup crushed shells. You may need slightly more or less, and you can adjust as needed.

Pull the thread to gather the bag. You should be able to just get it closed, but not be able to see any of the loose shells. Add a few stitches through the top to make sure it stays closed, knot the thread and clip.

Grab the fabric you're using for the outside. The pattern says to cut a 5 1/2" square, but I went with 6".  To smooth out the top, add a small handful of fiberfill before covering with the fabric.

Cover with the fabric, then roll the silicone ring into place in its notch on the pincushion base.

Adjust the fabric so it's taut and the gathers are even. Trim the fabric about 1/4 - 5/8" from the ring.

Snap the top ring on and it's ready for pins. So easy!

The ground nuts give it a good weight, so it won't move around as you're trying to use it. I like that it has some height, while I was still able to use my new favorite pincushion stuffing. Where can you get ground walnut shells? I gotcha covered - click here, and use the coupon code AHNUTS for 25% off through 3/7/17!