The Protect Your Tech Challenge is over, so now I can share my project with you. Every time I think I’m done using the leather I cut off to refashion this coat, I find something new to do with it. Believe it or not, I still have a little bit left, so I can’t guarantee you’ve seen the last of it.
When I was asked to create a holder for a cell phone or tablet using recycled materials, it was important to me that as many of the materials were reused from something else as possible. The only thing I ended up using that was brand new was the thread. Seriously, I draw the line at trying to reuse thread…just, no.
This is what I used:
leather – from refashioned coat
hook and loop – from a duffle bag
D ring – from a bag
clip-on wrist strap – from an old point and shoot camera bag
lining fabric – scraps left from my Pan Protector and Hot Pad project
webbing – from a belt
To create my pattern, I drew a rectangle that measured 3/4” larger than my phone on all sides. My phone is pretty thin (Samsung Galaxy SIII) so be sure to take the thickness of your phone into account when drawing your pattern. I used something with a rounded edge to round the two bottom corners. If I could remember what that was, I’d tell you, but it was probably a jar or something similar.
After you’ve drawn your pattern, cut two pieces from the leather (or whatever fabric you’re using) for the outside and two from the lining fabric. You’ll also need a 1 1/4 by 2” piece of leather for the side loop. Cut the 5/8 to 3/4” wide hook and loop 1 1/2” long. The webbing I used was 1 3/4” wide and had a finished end, so I cut it 3 3/4” long. If you’ll have to finish the end, cut it 1/2” longer, fold it under 1/4” twice and stitch.
Sew the loop piece of the hook and loop to the front leather piece, centered side to side and 2 1/4” from the top edge. Sew the hook piece to the webbing, 1/4” from the finished end.
Fold the 2” sides of the small piece of leather under 1/4” and stitch.
Slip into the D-ring and fold, wrong sides together.
Use binder clips to clip the two remaining pieces of leather right sides together. Slip the D-ring loop into one side with the ring inside, 1” from the top. Stitch 1/4” from the edge, leaving top open. Do the same with the lining, without the D-ring loop, and leave a 4” opening at the bottom.
Turn the lining right side out. Stuff it into the leather piece. Clip the top edges of both together. Slip the webbing between the layers , opposite the front hook and loop (the loop part) with the hook and loop on the webbing facing the lining. In the photo you’ll see my webbing sticking up above the edge, which is only because I started out with it too long. Yours should be even with the edge.
Stitch around, 1/4” from the edge.
Turn right side out through the opening in the bottom of the lining. Stitch the opening closed by hand or machine.
Push the lining to the inside. Roll the seam with your fingers until it is completely turned. Stitch around close to the upper edge.
For the flower embellishment, cut your favorite shape from the leather. I also cut a smaller starburst shape for the center to add a little more texture.
Stitch onto the webbing through the button.
Clip the wrist strap onto the D-ring and it’s finished. If you don’t have a wrist strap, some narrow webbing stitched together and a carabiner of some kind will do the trick.
My phone fits in the case perfectly without my phone cover, however I’d make it larger if you want your cover to stay on.
I’d like to thank everyone who took the time to vote for my project in the challenge. I appreciate the support!