Did you ever have a project that just seemed doomed from the start? Did you power through anyway, sure that it would work out in the end? If you answered yes to either of these questions, you understand my week. Fortunately, it was worth the struggle. This is a revisit to a project I showed you last month, Reversible Coffee Cup Sleeves, but a little more advanced version. One thing I will say right up front, do NOT make this using burlap, like I did, unless you’re up for a challenge.
You’ll need two pieces of cotton fabric (or one cotton and one burlap, if you’re ready for that ride) and a piece of InsulBrite*, cut using this pattern, making sure you flip it over so the two pieces of cotton are opposites. Don’t use the pattern from the previous sleeve, as this one is a little bigger. One of the many lessons I learned along the way while making this thing.
You’ll also need about 14” of bias tape, a small piece of clear vinyl (cut from the pattern), two 5/8” or 3/4” buttons and a small piece of elastic or half of a stretchy hair tie.
*InsultBrite is insulated batting. It has a shiny silver side and feels crunchy when you squish it. If you’d rather use the batting/ironing board fabric method I used previously, follow the instructions here.
Sandwich the upper edge of the vinyl into the fold of the bias tape.
Stitch close to the edge of the fabric. Cut the ends off even with the vinyl.
Press one end of the remaining bias tape under. Slide the left side of the vinyl into the fold, lining up the pressed end with the top. Place the vinyl on the sleeve according to the pattern. This part is tricky because you can’t pin the vinyl, so you have to hold it in place while you stitch around the remaining three sides, near the edge of the bias tape. Fold the tape around the corners.
When you reach the end, fold the end under. I clipped off the corners so they wouldn’t show. Stitch the remaining tape down so it matches with the top of the tape on the vinyl.
Stitch around the three sides again, close to the outer edge. Stitch the corners if necessary.
Lay the piece with the vinyl on it down, window up.
Add the piece of elastic on the straighter end, with the loop to the inside.
Add the other sleeve piece, face down.
Next add the InsulBrite. Pin everything in place.
Stitch around the edges with a 1/4” seam. Back stitch over the elastic. Leave an opening at the bottom the size of the vinyl window.
Carefully turn right side out. Press, turning in opening. This is where my burlap got a little ugly.
Stitch all the way around near the edge. Ordinarily, that would be enough, but because my burlap went a little crazy, I also did a zigzag stitch over the edge to keep it from unraveling.
Mark the spot for the button as shown.
Stitch the buttons on, one on each side, sliding a toothpick under each so there’s room for the elastic to loop around.
Here’s a page of printable love notes I made that fit inside the window.
And, of course, it’s still reversible.
The pocket is also a great way to give a coffee gift card. Just know that the card is flat and the cup is not, but it probably won’t stay there for long anyway!